CAD mount for a bearing to be used as a wheel.
 

I am attempting (without much success) in designing a mount for a load-bearing bearing. The mount should go on the weird-looking, upside-down T piece inside the long bar (see attached). The bearing is to be placed so that the weird piece can roll inside the long bar.

:deadhorse:

Re: CAD mount for a bearing to be used as a wheel.
 

What direction is the load being borne? Is this module being compressed vertically by the load, or ?? (most likely if it's a drive module)

By roll inside the bar, do you mean for it to rotate around the axis through the center of the long axis of the tang (upside-down T- piece) or something else?