Chief Delphi - KOP Chassis axle bolt issues...

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)

- Kit & Additional Hardware (http://www.chiefdelphi.com/forums/forumdisplay.php?f=55)

- - KOP Chassis axle bolt issues... (http://www.chiefdelphi.com/forums/showthread.php?t=141494)

MrBasse

11-01-2016 19:05

KOP Chassis axle bolt issues...

We had two of our axle bolts that didn't fit through any of the bearings. The bearings measured to spec, but the bolts were oversized for the bearing whole by .008". Anyone else notice this? A quick trip to the flap wheel solved our issue but we had to remove a lot of plating for almost an inch past the threads.

rsisk

11-01-2016 19:08

Re: KOP Chassis axle bolt issues...

Had same problem on Saturday. Hit them a bit with a belt sander and problem was solved.

All times are GMT -5. The time now is 00:29.