OM5P-AN Flashing Timeout
 

Every time I try to flash the new radio (using FIRST's utility), I get the error message "Bridge firmware load failed: Timeout flashing radio." It's able to detect when I power-cycle the radio, and begins to flash, but then just times out and never finishes. Firewall is disabled and the program is run as administrator. Anyone have any ideas?

Re: OM5P-AN Flashing Timeout
 

The KOP radio should already have the right firmware.

Have you tried these instructions for flashing the firmware?
http://files.andymark.com/OM5P-AN_QuickAP_Setup.pdf

Re: OM5P-AN Flashing Timeout
 

Are you sure that's the same firmware as the FIRST firmware?

Re: OM5P-AN Flashing Timeout
 

No, but Andymark is pretty good about those things. It is a link from the Andymark Webpage for the Radio. We will be flashing the radios this evening. I'll let you know if it works.

http://www.andymark.com/OM5P-AN-p/am-3277.htm

Re: OM5P-AN Flashing Timeout
 

The instructions on the AndyMark page are for non-FRC use applications.

For FRC, you'll want to follow the directions here:
Programming for Home Use for FRC

Re: OM5P-AN Flashing Timeout
 

The andymark instructions worked for me. We could not get the frc configutation tool to work.