pic: What's weird with this image
 

Re: pic: What's weird with this image
 

Talon SR's are Y-cabled and yet are being driven in reverse of each other... some how?

Re: pic: What's weird with this image
 

Looks like someone's been playing with the calibration on those Talon SRs and managed to calibrate one backwards. I don't see a method to get back to default calibration, so you're probably stuck with just re-calibrating them

Re: pic: What's weird with this image
 

We tried recalibrating, although we need to try again since I'm not sure they flashed green afterwords. Anyway, we have motors connected to each talon and both motors turned in the same direction. It must be that the internal electronics of one of the talons are reversed at the LED.

Re: pic: What's weird with this image
 

The one connector is a different shade of yellow.

Re: pic: What's weird with this image
 

The zipties aren't clipped! :ahh:

Re: pic: What's weird with this image
 

I would answer but I have literally no clue what is going on, more or less know what's wrong

Re: pic: What's weird with this image
 

That's a more remote possibility, but possibly true. Unless you have the exact same motors wired the exact same way, they might still turn differently. If a multimeter reads the same voltage when you put the red probe on M+ and the black probe on M-, then I would definitely agree with your assessment.

If it is bad internal LED wiring and the Talon is new, I would talk with Vex, Andymark, Cross the Road, or FIRST about getting a replacement. That LED is valuable for troubleshooting, and if all the fault codes are in flashing green, that's going to be extremely confusing.

Re: pic: What's weird with this image
 

I would check your PWMs and make sure both are inserted the correct way

Re: pic: What's weird with this image
 

But a PWM is signal power ground. It shouldn't work if it is plugged in backwards.

Re: pic: What's weird with this image
 

Be careful with shouldn'ts. We have encountered similar issues with backwards PWMs in the past.

Re: pic: What's weird with this image
 

I agree this is odd.

Does the condition move if you swap the "Y" output on the motor controllers?
As in the motors do the opposite as they are doing now.

Try swapping the y cable to the one used on the other side and note if the condition follows.
Or just swap the "Y" cables on the RoboRio.

Does the condition follow the cable or stays with the motor controllers?

I would make sure when recalibrating not to use a "Y" cable.
And test each motor separately and not on the "Y cable.
If the problem still exists only when on that specific Y cable, its got issues.

This should narrow down the issue to the cable or one motor controller.

Just curious is the voltage output of those motors indeed opposite to each other.

Hope you get this sorted.

Aloha and good luck this season!

Re: pic: What's weird with this image
 

We did not check with a multimeter so that is a possibility.


We did swap the PWM cables between the talons and on the roboRIO. The problem always stuck on one of the talons (I believe the one on the right of the image).
As I said before, the direction of the motors was the same. We did not test the voltage yet, however.

Re: pic: What's weird with this image
 

I bet one of the leds is burned out. We have a similar issue, but ours is always green on an old one. Does that one ever turn green?

Re: pic: What's weird with this image
 

This is always backward of what the signal is. When we say forward, it turns red; When we say backward, it turns green.