Chief Delphi - Talon SRX not visible on CAN

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)

- Electrical (http://www.chiefdelphi.com/forums/forumdisplay.php?f=53)

- - Talon SRX not visible on CAN (http://www.chiefdelphi.com/forums/showthread.php?t=142208)

TimTheGreat

20-01-2016 16:52

Talon SRX not visible on CAN

Our Talon SRX was working fine for several days while we were driving the robot. However, it just stopped working and we have no idea why. It is not visible on the roborio and sits there flashing green. According to the manual, flashing green means calibration or forward movement, but its not outputting anything and we never triggered calibration, so we have no idea whats wrong. Any help would be appreciated!

ozrien

20-01-2016 17:03

Re: Talon SRX not visible on CAN

It sounds like the BC calibration button is stuck it held down. Can u try press/releasing the BC cal button?

TimTheGreat

20-01-2016 19:17

Re: Talon SRX not visible on CAN

Quote:

Originally Posted by ozrien (Post 1527427)

It sounds like the BC calibration button is stuck it held down. Can u try press/releasing the BC cal button?

Yup the button was held down. Do you know what causes this? Is it the large bumps from going over obstacles?

Al Skierkiewicz

21-01-2016 07:46

Re: Talon SRX not visible on CAN

Tim,
I have not seen this occur in the past. It is mostly caused by a sharp object getting into the button and pushing it hard. Often a dropped tool.

TimTheGreat

21-01-2016 10:36

Re: Talon SRX not visible on CAN

Quote:

Originally Posted by Al Skierkiewicz (Post 1527684)

Tim,
I have not seen this occur in the past. It is mostly caused by a sharp object getting into the button and pushing it hard. Often a dropped tool.

I don't remember seeing anything. Could it have been the screw that holds the breakout cable cover?

Al Skierkiewicz

21-01-2016 11:43

Re: Talon SRX not visible on CAN

Not in my experience.

All times are GMT -5. The time now is 02:35.