AM14U3 Opening kit bumpers question!
 

I am wondering, based on the rulings in 4.7, R19, which has a statement "... If a side is shorter than 8 in., the entire side must be protected by
BUMPER..." If you use this kit from AndyMark (http://www.andymark.com/AM14U3-p/am-14u3-fro.htm) but the two halves of the End Sheet are less than 6", all we need to do is cover them completely in bumper and it is legal?

Re: AM14U3 Opening kit bumpers question!
 

As far as bumper rules are concerned, the front of the robot in the Andymark link is 1 side. The fact that there is a cutout in it doesn't matter, so you still need 8 inches of bumper on each side of the outside corners.

Re: AM14U3 Opening kit bumpers question!
 

Thank you for the clarification.