Chief Delphi - AndyMark Nano Tubes

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)

- General Forum (http://www.chiefdelphi.com/forums/forumdisplay.php?f=16)

- - AndyMark Nano Tubes (http://www.chiefdelphi.com/forums/showthread.php?t=142724)

dmorewood

28-01-2016 16:49

AndyMark Nano Tubes

Hi everyone. We've run into a bit of trouble while designing a custom version of AndyMark's nano tube gearboxes. The intermediate shaft has a bearing that I've never seen before. The flanged one that is very skinny. Does anyone have any idea what the exact bearing is or where to buy it. It's not listed on the AndyMark page.

FrankJ

28-01-2016 17:04

Re: AndyMark Nano Tubes

Is it this? If not, give Andymark a call. The are very helpful.

Peyton Yeung

28-01-2016 17:42

Re: AndyMark Nano Tubes

1 Attachment(s)

I believe FrankJ is correct. CAD states it is an FR6 bearing. 0.375" ID 0.875" OD and .218" thick. Included is a picture of one I installed backwards.

dmorewood

28-01-2016 21:29

Re: AndyMark Nano Tubes

Thank you I found the parts I need.

On a side note, has any one else noticed that all the CAD files seem to have disappeared from the downloads tab at Andymark.

DiehardCybercard

29-01-2016 12:01

Re: AndyMark Nano Tubes

Quote:

Originally Posted by dmorewood (Post 1531775)

Thank you I found the parts I need.

On a side note, has any one else noticed that all the CAD files seem to have disappeared from the downloads tab at Andymark.

Are there particular files that seem to be missing or a particular webpage? I'd be happy to double check pages and add CAD files!

All times are GMT -5. The time now is 10:09.