Chief Delphi - pic: Team 1305's second robot.

Page 2 of 2

Show 100 post(s) from this thread on one page

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)

- Extra Discussion (http://www.chiefdelphi.com/forums/forumdisplay.php?f=68)

- - pic: Team 1305's second robot. (http://www.chiefdelphi.com/forums/showthread.php?t=143488)

Median240

10-02-2016 07:00

Re: pic: Team 1305's second robot.

Quote:

Originally Posted by PowerfulKitty (Post 1537898)

What about bumpers? Does your intake come in?

Yes. It slides on rails in and out. When in the close position the front of the intake is fully inside the frame. If you look closely at the plates which hold the intake you can kind of see the sliders.

GeeTwo

10-02-2016 08:17

Re: pic: Team 1305's second robot.

Quote:

Originally Posted by Median240 (Post 1537939)

Hopefully this answers your questions.

Yes, thanks. The angle is rather extreme; I did not see that the belts were centered over the intake area. Now that I'm looking for it, it's almost obvious.

Median240

10-02-2016 16:05

Re: pic: Team 1305's second robot.

Quote:

Originally Posted by GeeTwo (Post 1537960)

Yes, thanks. The angle is rather extreme; I did not see that the belts were centered over the intake area. Now that I'm looking for it, it's almost obvious.

When we get it fully built I plan to put a few videos of it in action up, so that might clear up anything else.

All times are GMT -5. The time now is 21:36.

Page 2 of 2

Show 100 post(s) from this thread on one page