[FTC]: I2C Extension Cables
 

Hi - Anyone know where one can get extension 4-wire I2C for Modern Robotics hardware? The team is trying to use a color sensor, but the cable is too short. They need about 12 inches. Alternatively, a source for male and female connectors would be fine and the team can build an extension cable (though pre-made would be best). Thanks.

Re: [FTC]: I2C Extension Cables
 

Vex has them for the Vex EDR line.

http://www.vexrobotics.com/extension-cables.html

The 4 wire ones come 12" long.

Re: [FTC]: I2C Extension Cables
 

Thanks Foster. Found them!

Re: [FTC]: I2C Extension Cables
 

Modern Robotics now has extension cables and pigtails:

http://www.modernroboticsinc.com/sensor-pigtail-kit

http://www.modernroboticsinc.com/sensor-extension-kit

Note that the Vex extension cables may need to have a side tab cut/sanded in order to fit in the connector. I haven't ordered any of the Modern Robotics extensions, but I'm guessing they don't have this issue.

Re: [FTC]: I2C Extension Cables
 

The modern robotics ones are about 9.5" long, driesman was looking for ones about 12" long. But they are lots cheaper than the VEX ones.