Chief Delphi - Bumper Mounting Locations

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)

- Technical Discussion (http://www.chiefdelphi.com/forums/forumdisplay.php?f=22)

- - Bumper Mounting Locations (http://www.chiefdelphi.com/forums/showthread.php?t=144917)

Bumper Mounting Locations

Is there a requirement to have an anchor point every 8" from the bumper to the robot frame? We we told that this was a requirement in the past, but i cannot find this requirement.

Re: Bumper Mounting Locations

Take a look at R26, it does not mention being attached, simply backed.

Re: Bumper Mounting Locations

Quote:

Originally Posted by Jarren Harkema (Post 1548577)

Take a look at R26, it does not mention being attached, simply backed.

That is correct.

Also, there is a requirement that the end half-inch of each bumper be supported, same place.

Re: Bumper Mounting Locations

Thank you, this is what I thought in reading r26. One other question, if the bumper end at an 1" vex upright, can you support just after it, that would be 1" from the end?

Re: Bumper Mounting Locations

Quote:

Originally Posted by c557paul (Post 1548703)

Thank you, this is what I thought in reading r26. One other question, if the bumper end at an 1" vex upright, can you support just after it, that would be 1" from the end?

Not quite sure what you're asking. The rule here is R26:

Quote:

Originally Posted by R26

BUMPERS must be supported by the structure/frame of the ROBOT (see Figure 4-9). To be considered supported, a minimum of ½ in. at each end of the BUMPER must be backed by the FRAME PERMIETER. Additionally, any gap between the backing material and the frame:

A. must not be greater than ¼” deep, or
B. not more than 8 in. wide.

Ideally, the last 1/2" must be backed by non-articulated frame. How far away a 1" wide piece of VersaFrame Tubing must be from the edge is probably an inspection discretion item, but I would aim to put the frame directly at the edge of the bumper, or a bit past.

Re: Bumper Mounting Locations

Eric,
Show me in the rules that a frame support must originate from the robot and not the bumper itself.
I see no such rule.

Sorry, couldn't find the old thread that has our discussion from before.

Glenn