Chief Delphi - Spartan Board not giving any output for gyro or 5v for the DIO.

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)

- Control System (http://www.chiefdelphi.com/forums/forumdisplay.php?f=177)

- - Spartan Board not giving any output for gyro or 5v for the DIO. (http://www.chiefdelphi.com/forums/showthread.php?t=145941)

thatprogrammer

19-03-2016 13:21

Spartan Board not giving any output for gyro or 5v for the DIO.

My team recently got our Spartan Board attached to our roboRIO. When we attempt to display its gyro value on the SmartDashboard, it outputs 0. In addition, our DIO ports only give off ~1.8v (verified using a multimeter). We noticed the board has a port labeled PWR, but we are not running any cable to it. Should we be running power through this port, and if so, where should this power come from?
Thanks!

thatprogrammer

19-03-2016 16:15

Re: Spartan Board not giving any output for gyro or 5v for the DIO.

Austin Schuh emailed me about this, and it turns out the Spartan Board requires 12v in order to work. There was no documentation on WCP's website, so we were unable to determine this. We have it up and running now though!

All times are GMT -5. The time now is 07:28.