![]() |
Kit of Parts Problems
Last night, our team met and we went through the kit of parts and looked at everything.
We've run into a problem, I think. We are missing a good amount of the parts that were supposed to be included in the kit. I also realize that we are supposed to be receiving parts via mail in the near future, so I wanted to just list everything we're missing and bounce it off you all - so I know what to call FIRST about and what to wait for in the mail. So, we are missing - Control System Plastic Shield for 25 pin connector (Not too important, I know) Quick-Disconnect Power Connector 10' #6 AWG Wire, Red Fasteners Helical Plastic Wire Wrap (1/4" diameter) Helical Plastic Wire Wrap (1/2" diameter) Motors and Pumps Van Door Motor - Bosch Instead, it seems we received 2 of Chiaphua motors and 2 of their matching gears. I need verification that we are not supposed to have two of these. We also received an orange 'torque motor,' but we're not sure of the manufacturer, and we can't find it on the list of kit parts. What is this, and are we supposed to have it? Pulleys The entire bag, containing: Bushing (for CMT Pulleys) (4) Alum. timing pulley - 20 tooth Plastic timing pulley - 30 tooth Plastic timing pulley - 60 tooth Springs Constant Force Spring, Small - we only received 1 Wheels 6" diameter wheelchair wheel As you can see, we're missing quite a bit. I didn't include the revolving light, since I know that's supposed to be shipped. What else should I expect, and what am I missing entirely!?!? |
Mike,
I went through our team's parts, and we are missing a couple small things too. I haven't checked everything yet, but... We also got no van door and two chalupa motors. This is a change (i have heard) and all teams had this change. Quick disconnect: I couldn't find them in our kit Wheelchair wheel: We got two of each... If you got only one 6", that's a mistake. Patrick |
Thanks Patrick. . .
We didn't get any 6" wheelchair wheels at all, but we got two 8" diameter wheels. I'll call about that, but it may not be such a big deal since we probably won't use 'em anyway. It's a relief to hear about those motors, though. |
Apparently there were some discrepancies between what was in the kit and what is on the list; there should have been an updated parts list distributed with the kit (we received ours at the kickoff).
|
Quote:
|
Quote:
~Christina |
Chiphua Motors
Quote:
- Katie |
Quote:
Would anyone be willing to post it for us so that we can get things straightened out? |
Quote:
|
Quote:
|
Our mistake
All,
There was a mistake in the manual file listing the actual kit of parts checklist. The valid checklist is getting posted to the website this morning. The CD manual editors also edited out part of the Robot section. Our bad for not catching it before its release. That's also getting updated on the website this morning. Please accept our apologies for the errors; you're seeing some growing pains. It doesn't make it any easier on you guys, or an excuse, just a reason. |
Thanks for the head's up. . . I'll go check it out now.
|
haha... i beat u all. we're missing our light. :(
|
Well, after going through the "2002 Kit of Parts Checklist" which was graciously put up today, I have realized that we are still missing a good amount of parts. These are the parts that are still MIA...
~Plastic Shield for 25 pin connector ~6" Wheelchair wheel (both of 'em) ~Constant Force Spring, small (one of 'em) ~1/4" Helical Plastic Wire Wrap ~1/2" Helical Plastic Wire Wrap ~The whole darn pulley bag Now, although this list is a bit shorter than the original, I just want to make sure that I am actually missing these parts or if anyone else is missing any of these. ~Christina |
Quote:
|
| All times are GMT -5. The time now is 01:26. |
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Copyright © Chief Delphi