Re: Using a 775pro in Dusty Conditions
 

As a point of reference, brushed motors wouldn't function on the moon at all, or would fail very quickly if they did. They can work on Mars because there's a thin atmosphere, but they cannot handle the vacuum on the moon. Outgassing of all the lubricants occurs, the brushes can be damaged (the presence of water vapor essentially lubricates the brush-commutator interface. Without it, damage rapidly occurs of graphite brushes), and the outgassing causes increased thermal load which cannot be transmitted to the surroundings well due to lack of atmosphere.

Regolith simulant is also INCREDIBLY abrasive. I would be very surprised if a 775pro held up to it for more than a few minutes here and there.

Re: Using a 775pro in Dusty Conditions
 

Way back in 2007- 2009 when the Regolith competition was one of NASA's centennial challenges, myself and a couple other industry folks decided to enter a couple of robots in our free time. Ended up placing 2nd and 3rd.. We ended up right behind Paul back when he was at WPI doing robotics then (and now with BiteForce).

To the best of my memory, all of our drives were fully sealed, both motors and gear trains. Just like FRC we really wanted to keep our drivetrain as bullet-proof as possible. If I recall correctly we used fully sealed Maxon motors as well. I believe they were brushless as well however that part i am not remembering as well.

Plus as Cory mentioned you really are not going to have the ability for convection to cool your motor out on the lunar surface.

My thoughts that the 775pro would likely meet a relatively quick death with the amount of dust kicked up. To my knowledge, the simulant is designed if to have relatively sharp edged particles that would replicate the lunar surface and not the water eroded particles that we typically see here on earth and thus be much more abrasive than normal sand, dirt etc...

Good luck!

Re: Using a 775pro in Dusty Conditions
 

The competition consists of two 10 minute runs and a 10 minutes practice run. Hardly enough time to ruin a sealed motor. I'm sure most motors within our price range would have trouble in the long run, but that's one of many reasons the Mars rovers cost a lot of money :)

Thanks for the recommendation Aren. I'll be sure to do my research on brushless motors before buying anything. Do you have any motors in mind?

Re: Using a 775pro in Dusty Conditions
 

Supercalifragilisticexpialidocious just seems so weak, now. :o

And I'll bet that Aren does have a brushless motor in mind. But it may have to stay there, for a while.

Re: Using a 775pro in Dusty Conditions
 

We smoked 2 of ours after the first official run but we had practiced with them for many hours prior to that. We smelled something burning and we opened up the box to find that lovely burnt plastic smell. 20 minutes between the practice and first run was all it took for the regolith to make its way into the boxes and wreck a couple of the motors.

It did plow into a boulder and go right over it though!

Re: Using a 775pro in Dusty Conditions
 

But Supercalifragilisticexpialidocious has a song.

Re: Using a 775pro in Dusty Conditions
 

https://www.youtube.com/watch?v=HaQt8wNrrqw

Re: Using a 775pro in Dusty Conditions
 

Dum-diddle-iddle-iddle, dum-diddle-eye!
Dum-diddel-iddle-iddle, dum-diddle-eye!