Jetson TX1 Devkit daughter card for four raspberry pi V1.3 cameras
 

Hello, I'm Liam from team 1559
Our team is planning on possibly designing and ordering daughter boards for the Jetson TX1. The daughter board would be able to support four raspberry pi V1.3 cameras. The board we design would be significantly cheaper than similar boards found online and our team would sell each board for $80. If any other teams using the Jetson TX1 for their robot this year are interested in purchasing one of the boards please reply, we would only be selling these boards if we have enough teams interested in purchasing the boards.

Re: Jetson TX1 Devkit daughter card for four raspberry pi V1.3 cameras
 

You might want to read through this thread. It has some info that I think might pertain to this situation revolving around what defines a cots part (given the 2016 rules of course).

Re: Jetson TX1 Devkit daughter card for four raspberry pi V1.3 cameras
 

I'd probably buy a couple. Not for FRC, but I'm doing a research project using the Jetson TX1 and we'd love to be able to easily hook up a handful of cameras.

Re: Jetson TX1 Devkit daughter card for four raspberry pi V1.3 cameras
 

Does this component need to be a COTS part to be used on a robot under the previous rules?

Re: Jetson TX1 Devkit daughter card for four raspberry pi V1.3 cameras
 

Would encourage you to post the design files for the board once you make it and not just offer to sell them. That should enable teams to make their own down the road. Just a suggestion.