Chief Delphi
Page 2 of 2 < 1 2
Show 100 post(s) from this thread on one page

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)
-   General Forum (http://www.chiefdelphi.com/forums/forumdisplay.php?f=16)
-   -   Encoders for CIM motors (http://www.chiefdelphi.com/forums/showthread.php?t=153347)

Ari423 10-01-2017 11:54
Re: Encoders for CIM motors
 
Just going to leave this here.
Quote:
Originally Posted by Mecanum Wheel (Post 1422518)
Hello Mark. Mecanum is a commonly misspelled word. There are multiple ways to say it but only one way to spell it. If you have any questions, feel free to ask. Until then, you may refer to this handy chart:

Munchskull 10-01-2017 12:06
Re: Encoders for CIM motors
 
Quote:
Originally Posted by Munchskull (Post 1628351)
Look for cimcoder on grabcad. There is a 3dprintable one there.
Just going to leave this here.


All times are GMT -5. The time now is 07:16.
Page 2 of 2 < 1 2
Show 100 post(s) from this thread on one page

Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Copyright © Chief Delphi