Radio Configuration
 

My team is trying to setup our radio. We have downloaded the configuration software. The error says:
Bridge configuration failed: Failed to change IP Address, please check for an adapter with the address: 192.168.1.51. Please ensure the bridge is connected to this computer and try again.
How do we correctly configure our radio?

Re: Radio Configuration
 

Did you fully disable the wireless adapter on that PC? Turning wifi off via hard button on a laptop is often not enough, you need to go into network settings in Windows, right-click the wireless adapter and hit "Disable".

That cleared this error up for me, then the configuration utility worked.

Re: Radio Configuration
 

Also make sure that the ethernet cable is plugged into the right port. The configuration utility should have a diagram highlighting the correct port.

Re: Radio Configuration
 

Our radio wont accept the bridge. It says the bridge firmware load failed. What should i do?