Chief Delphi - Problems with CAN and Roborio Web system configuration

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)

- FRC Control System (http://www.chiefdelphi.com/forums/forumdisplay.php?f=176)

- - Problems with CAN and Roborio Web system configuration (http://www.chiefdelphi.com/forums/showthread.php?t=153902)

jcmythree

19-01-2017 08:33

Problems with CAN and Roborio Web system configuration

We do not show a CAN interface on the web based system configuration for Roborio Any suggestions as to what may be causing this problem would be appreciated.

Bkeeneykid

19-01-2017 10:01

Re: Problems with CAN and Roborio Web system configuration

We need a little bit more information. What do you have on your CAN network? Are these devices showing a CAN fault (see the documentation for each device to see what this looks like)? Is the CAN network properly terminated at the PDP or with a 20 Ohm resistor? Any other extraneous info might also be helpful in diagnosing your problem.

All times are GMT -5. The time now is 11:15.