Chief Delphi

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)
-   General Forum (http://www.chiefdelphi.com/forums/forumdisplay.php?f=16)
-   -   3D printable gear hook (http://www.chiefdelphi.com/forums/showthread.php?t=154881)

bobbysq 07-02-2017 09:01

3D printable gear hook
 
I modeled the hook from the end of the lift peg so teams can 3D print it and get their own.

https://www.thingiverse.com/thing:2091279

bobbysq 08-02-2017 12:26

Re: 3D printable gear hook
 
A bit of an extra note since I lost the ability to edit.

After printing it, it appears that it has a very tight fit in the spring. In fact, it's so tight that you need to install it by actually screwing it in to the spring, letting the metal dig through the plastic. Because of this, you will want to use a good amount of infill to keep it from shearing. I printed it at 20% and I nearly snapped it trying to get it in, so you may want a bit more if you're worried.

chapman1 08-02-2017 17:12

Re: 3D printable gear hook
 
Thanks for sharing!


All times are GMT -5. The time now is 01:01.

Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Copyright © Chief Delphi