i need some help in inventor...
 

is there anybodyt hat is on aim and could help me with some stuff in inventor?

thanks
alex

my aim sn is Pit Bull 1126

Re: i need some help in inventor...
 

how do you make the size of a circle 12 inches??

Re: i need some help in inventor...
 

Draw the circle in sketch mode, hit general dimension (D Key) then click the edge of the circle and move the mouse inward. A Dimension should appear going from edge to edge across the middle of the circle. Click anywhere inside it and it should bring up a little window. Just type "12 in" in and hit enter.

Re: i need some help in inventor...
 

If you would like, I have a powerpoint I can e-mail to you. Contact me on AIM

screen name is VCUBASSPLAYA

Gabe Goldman
President and founder of the VCU robotics club

Re: i need some help in inventor...
 

I heard 12 inches. You aren't trying to make the kit wheel are you? Because it's already drawn up on www.firstcadlibrary.com

Re: i need some help in inventor...
 

Sure I'll lend you a hand

Re: i need some help in inventor...
 

no im making it 12 so we can have it balanced with those 12" kit part wheels

Re: i need some help in inventor...
 

If you already have the wheel drwan and are trying to change the actual dimensions of you just have to click on "Extrusion 1" and select "change dimension"

Re: i need some help in inventor...
 

NEW UPDATE:

i have finished the wheel and had help with part 2 from coffeeism and fluffy blink. coffeeism had shown me the way he had done it but i still couldn't do it. thanks you to for what u have done. and gilberts too thanks for your instructions.