Chief Delphi - Getting off CMT pulleys

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)

- Technical Discussion (http://www.chiefdelphi.com/forums/forumdisplay.php?f=22)

- - Getting off CMT pulleys (http://www.chiefdelphi.com/forums/showthread.php?t=24515)

Adam Y.

29-01-2004 18:52

Getting off CMT pulleys

Gosh darn it. I installed a CMT pulley and I did not know that it would be permamently stuck on the globe motor. Does anyone have any ideas of getting them off of the shaft?

Rickertsen2

29-01-2004 19:12

Re: Getting off CMT pulleys

Quote:

Originally Posted by Adam Y.

Gosh darn it. I installed a CMT pulley and I did not know that it would be permamently stuck on the globe motor. Does anyone have any ideas of getting them off of the shaft?

What's a CMT pulley?

Adam Y.

29-01-2004 19:23

Re: Getting off CMT pulleys

They are just a pulley with a special hub that was in one of the robot kits.

Gary Bonner

29-01-2004 21:59

Re: Getting off CMT pulleys

If I recall correctly, putting the set screw in the other hole releases the hub if you didn't over torque the screw in the first place.

Jack21

30-01-2004 07:08

Re: Getting off CMT pulleys

Quote:

Originally Posted by Gary Bonner

If I recall correctly, putting the set screw in the other hole releases the hub if you didn't over torque the screw in the first place.

you could try a small gear puller (common at most flea markets)

All times are GMT -5. The time now is 15:37.