Wire Gauge Question
 

I was wondering a bit about the wire gauge requirements, specifically for the Fisher Price motor. All the rulebook seems to say is that the connection from the breaker panel to the speed controller has to be 10 AWG (or larger) wire, but not what the wire can be from the speed controller to the motor. I assume it should also be 10 AWG, but I noticed on the QA System that the Globe motor can have 16 AWG wire from the speed controller. Anybody know if this is also the case for the Fisher Price?

Re: Wire Gauge Question
 

Neghman,
5.6.2 Wire Size
At any given current level, the smaller the gauge of a wire, the greater the voltage drop and power loss in the
wire due to its inherent resistance. FIRST has specified minimum allowed wire sizes based on guidelines
used in the automotive industry. The wires and cables included in the Kit are intended for specific uses.
Table 5.2 shows the minimum wire sizes allowed for hookup of the various control system devices. Note that
you may use larger wire sizes than indicated in the table or shown on the 2004 Robot Power Distribution
Diagram.
The secret is in looking at the difference in stall currents between the globe and FP.