Chief Delphi - White Paper Discuss: C Programming and Autonomous Modes for Newbies

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)

- Extra Discussion (http://www.chiefdelphi.com/forums/forumdisplay.php?f=68)

- - White Paper Discuss: C Programming and Autonomous Modes for Newbies (http://www.chiefdelphi.com/forums/showthread.php?t=31869)

White Paper Discuss: C Programming and Autonomous Modes for Newbies

Thread created automatically to discuss a document in the White Papers.

C Programming and Autonomous Modes for Newbies by cbolin

Re: White Paper Discuss: C Programming and Autonomous Modes for Newbies

Congratulations, Chuck--I guess it takes a South Carolinian to speak to a South Carolinian. This is the first programming white paper that actually clicked with me. (I'm not a programmer by any stretch. But I guess that's obvious).

One question, on the line tracking example in the autonomous notes...at Position D, when the left sensor is made, shouldn't the robot turn to the left instead of the right?

But other than that, bravo!

Re: White Paper Discuss: C Programming and Autonomous Modes for Newbies

I read this yesterday morning. I thought it was great also. I sent him a PM with my thanks.
I didn't notice this error yesterday but now reading it again I do see it. It seems like he messed up that whole section.

Here is what I think It should look like:

Code:

//place this line before while (autonomous_mode).

        unsigned char s_left = rc_dig_in01;

        unsigned char s_middle = rc_dig_in02;

        unsigned char s_right = rc_dig_in03;

//place this after Getdata(&rxdata);

if (s_left == 0 && s_middle == 1 && s_right == 0) 

// Middle sensor on

// Go straight

{

        pwm01=160; //left motor

pwm02=160; //right motor

}



else if (s_left == 1 && s_middle == 1 && s_right == 0) 

// Left 2 sensors on

// Turn soft Left

{

pwm01=127; //left motor

        pwm02=160; //right motor

}



else if (s_left == 1 && s_middle == 0 && s_right == 0) 

// Left sensor on

// Turn Hard Left

{

pwm01=127; //left motor

        pwm02=180; //right motor

}



else if (s_left == 0 && s_middle == 1 && s_right == 1) 

// Right 2 sensors on

// Turn soft right

{

pwm01=160; //left motor

pwm02=127; //right motor

}



else if (s_left == 0 && s_middle == 0 && s_right == 1) 

// Right Sensor on

// Turn Hard Right

{

pwm01=180; //left motor

        pwm02=127; //right motor

}



else          //stop

{

pwm01=127; //left motor

        pwm02=127; //right motor

}

The other error I saw was in Table 3 First Row, First Column (on the bottom of page 5), that should be Turn Left. The numbers and diagram is still correct

Again, Great Job Chuck

Re: White Paper Discuss: C Programming and Autonomous Modes for Newbies

I am a newbie; this is my first year in FRC. I know how to program in many other languages, but C is a new one for me. If anyone has any tips or advice on programming for a newbie, I'd be much obliged.:D All I have to learn it at home is a college textbook...I'm a freshmen in High School! Anyway, any help would be greatly appreciated. Thanks!