Chief Delphi - Sliding door motor shaft support

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)

- Motors (http://www.chiefdelphi.com/forums/forumdisplay.php?f=52)

- - Sliding door motor shaft support (http://www.chiefdelphi.com/forums/showthread.php?t=32788)

Max Lobovsky

14-01-2005 18:29

Sliding door motor shaft support

Have you ran the sliding door motor with or without support for the shaft in the past? If so, approximately how much tension was on it (or just tell me the size of the sprocket and I can figure it out). Thanks.

Cory	14-01-2005 18:30

Re: Sliding door motor shaft support

We ran it supported only by one side in 2003. I believe we had a 3" drum that we attached to the shaft to wind a cable around

Max Lobovsky

14-01-2005 18:37

Re: Sliding door motor shaft support

supported on one side meaning no supports in addition to the motor gearbox itself?

Cory	14-01-2005 18:39

Re: Sliding door motor shaft support

Quote:

Originally Posted by Max Lobovsky

supported on one side meaning no supports in addition to the motor gearbox itself?

Correct.

All times are GMT -5. The time now is 00:58.