Chief Delphi - Modelling in Matlab

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)

- Motors (http://www.chiefdelphi.com/forums/forumdisplay.php?f=52)

- - Modelling in Matlab (http://www.chiefdelphi.com/forums/showthread.php?t=33178)

randys_2002

21-01-2005 11:12

Modelling in Matlab

I would like to get some assistance on creating a model for a switched reluctance motor in Matlab. Also a DSP controller to minimize torque ripple. Any assistance or references would be appreciated.

Mike Betts

21-01-2005 11:23

Re: Modelling in Matlab

Randys,

You are on the wrong forum. On this forum, we are all associated with FIRST which targets a high school audience.

The vast majority of us do not use MATLAB. We use MPLAB which is a software development tool for Microchip products.

Regards,

Kyle Fenton

21-01-2005 11:30

Re: Modelling in Matlab

Quote:

Originally Posted by randys_2002

I would like to get some assistance on creating a model for a switched reluctance motor in Matlab. Also a DSP controller to minimize torque ripple. Any assistance or references would be appreciated.

I think you have the wrong program. Matlab is a program that computes and manipulates matrices. You might be thinking of Simulink, which can model and simulate.

Katie Reynolds

21-01-2005 11:47

Re: Modelling in Matlab

randys_2002,

There's no need to make a post about this topic three times on these forums. Continue this discussion, if you need, in your first post on this topic.

http://www.chiefdelphi.com/forums/sh...d.php?p=321191

All times are GMT -5. The time now is 05:51.