Re: pic: 1382 Brazil - Gear box
 

lexan is polycarbonate.....just more expensive since it is a trademarked name from GE....

Re: pic: 1382 Brazil - Gear box
 

I suspect that they've run some numbers and are sure that the gears will be up to the loads they are expecting. What concerns me is that as the gears wear, their strength will go down. Depending on what type of plastic it is, even exposure to sunlight could weaken it. What works now may not work a few weeks from now after some hard driving. I guess it hinges on the material. If they manage to get away with it, they'll have a nice little advantage in not having heavy steel gears.

As an aside, I noticed the other day that aluminum gears were available, and cheap! Is there any marked difference between an aluminum gear and say a nylon equivalent? Any practical experience with them?

-Andy A.

Re: pic: 1382 Brazil - Gear box
 

Care to give the source?

Re: pic: 1382 Brazil - Gear box
 

For what it's worth, 188 managed to break a couple aluminum ones last year.... Actually, I ended up misjudging the loads on the gears a little, and ended up with too much torque on one particular pair of gears. (This was, mind you, in a very powerful transmission.) The aluminum gears above it (i.e. spinning faster, with less torque) in the transmission have worked perfectly, without so much as an unsightly mark on the teeth, after two regionals, the championship and an off-season event. For reference, the failed gears (26 & 84 T, 20° PA, 3/16" FW, 0.7 M, 2024-T4) were spinning at 3500 & 1000 (free) rpm, respectively, with around 1.2 HP driving them. The gears of the same size and composition (and the 32 P, 20° PA ones, which are very similar) at 5500 (free) rpm and above were undamaged and still function as intended. We actually bought nylon ones as spares for the upper stages, when we replaced the broken gears--thinking that the aluminum might have been unsuitable for those too--but as it turned out, they were never needed. Without knowing too much about the exact plastic properties under load, I would simply note that the tensile yield point is much lower for the nylon than the aluminum--a definite warning sign.

Both of the following stock aluminum gears, and can (theoretically) cut custom sizes of stock pitches, including the ever-popular :mad: 0.7 module at PIC; also, be wary of the stamped 5052 aluminum gears at SDP/SI--I don't think they're too precise:
SDP/SI
PIC Design

Re: pic: 1382 Brazil - Gear box
 

We'll be using pneumatics to make the Gear's change.

The problem is that we'll have to be stopped to make this happen.

I'm more into eletronics and programming so I can't help you guys with the Gear Rations and stuff, but I'll se if I can get someone tomorrow to answer you guys!