pic: Chief Delphi exposed!!!
 

Re: pic: Chief Delphi exposed!!!
 

16 VICTORS!!!!! what are you going to do with all of thoes?

Re: pic: Chief Delphi exposed!!!
 

They have two identical boards. Hmm...
Only eight motors this years. Very interesting...

Re: pic: Chief Delphi exposed!!!
 

well your right. two boards that are identical in every way except they dont go on the same robot.........

Re: pic: Chief Delphi exposed!!!
 

Cough, cough, practice robot, cough...

Re: pic: Chief Delphi exposed!!!
 

Somehow they are using 6 40 amp breakers on each....even though there are only 4 things that can be on 40 amps

Re: pic: Chief Delphi exposed!!!
 

I thought it was kinda obvious with two power distribution bloxks visible.

Re: pic: Chief Delphi exposed!!!
 

5.3.9.1 Circuit Breaker / Fusing Rules

<R79> You must use the auto resetting Snap Action circuit breakers provided in the Kit Of Parts to protect all the active Circuit Breaker/ Power Distribution Panel branch circuits from overload.

<R80> You must protect the Robot Controller power feed with a 20A Circuit Breaker. You may not connect any other electrical load to this breaker.

<R81> You must protect the Air Compressor power feed with a 20A Circuit Breaker. You may not connect any other electrical load to this breaker.

<R82> You must protect the power feed to Custom Circuits and Additional Electronics with a 20A Circuit Breaker.

<R83> Speed Controllers may be protected by 20A, 30A, or 40A Circuit Breakers. Speed Controllers may power motors or devices of any size.

R83 seems to indicate that you can plug any of the motors into the 40 amp breakers. I know this is against/different than what we have had to do in prior seasons, but I still think it reads that way.

(sorry for posting the entire section, but I think it helps explain)
-Bill

Re: pic: Chief Delphi exposed!!!
 

Looks good guys, congrats on a good elec board!!

Re: pic: Chief Delphi exposed!!!
 

Speaking of practice... does anyone know if there will be practice fields at regionals again this year? It was a great help last year for tweaking autonomous.

Re: pic: Chief Delphi exposed!!!
 

I like the use of perforated sheet. Did it work out so there was always a hole where you needed it and you never had to drill?

Re: pic: Chief Delphi exposed!!!
 

Very nice.
i aspire to be a mech-e but i think everyone in first can appreciate a nice clean elec board.

again i say Nice job Chief Delphi on a clean elec board.

Re: pic: Chief Delphi exposed!!!
 

thanks my friends!!! just think of how the judges will feel being able to see all the electrical clean and simple!!! i think you all should consider doing the same so i can see how you guys and gals do your electronics!!! tty soon!!!

Re: pic: Chief Delphi exposed!!!
 

Is that all 10 ga. wire? The wiring rules were changed this year you don't have to go any bigger than 12 coming off the distrobution board. The 20's and 30's can be even a smaller gauge. Just something to remember if you're looking to shave off some extra pounds at the end of build season.

Re: pic: Chief Delphi exposed!!!
 

yes, ten guage wire all the way around, but wieght wise, we dont even know yet, i think the wiring is like 15 pounds or more....