Chief Delphi - ADXRS300EB gyro help

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)

- Programming (http://www.chiefdelphi.com/forums/forumdisplay.php?f=51)

- - ADXRS300EB gyro help (http://www.chiefdelphi.com/forums/showthread.php?t=34214)

Chris Bright

08-02-2005 16:51

ADXRS300EB gyro help

I am wondering if any one can confirm the pins for the evaluation board is pin 1 = power, pin 2 = rate out and pin 8 = ground. I tried using the default code and only change was the gyro selection. I am getting no gyro rate in the terminal.

kjohnson

08-02-2005 16:54

Re: ADXRS300EB gyro help

Kevin's default gyro code is set to analog 1 - make sure your gyro is connected to analog 1 unless you have changed it in the code.

Chris Bright

08-02-2005 17:02

Re: ADXRS300EB gyro help

It is. i get a rate sometimes but never higher than five

Kevin Watson

08-02-2005 17:33

Re: ADXRS300EB gyro help

Quote:

Originally Posted by Chris Bright

Did you connect AVCC (pin 1) to PDD (pin 13)?

-Kevin

NoRemorse

08-02-2005 17:59

Re: ADXRS300EB gyro help

Thats a negative. didn;t know you had to do that, thanks for the info!

All times are GMT -5. The time now is 23:56.