Chief Delphi - OI/Control Board LEDs during Autonomous

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)

- Programming (http://www.chiefdelphi.com/forums/forumdisplay.php?f=51)

- - OI/Control Board LEDs during Autonomous (http://www.chiefdelphi.com/forums/showthread.php?t=34515)

OI/Control Board LEDs during Autonomous

Do you know how to set the LEDs during Autonomous? (Pwm1_green/Pwm1_red)
It helps a lot to be able to know what the robot is doing at a specific moment.

I know that I am writing it out, because the same code works outside of autonomous. (I just copied the part of user_routines and changed p1_x to pwm01, etc.)

Do I have to use the dashboard to read these? If so, how do I write to the dashboard?

What about LED's hooked up to outputs on the RC itself? Is it legal to do this for feedback purposes?

Re: OI/Control Board LEDs during Autonomous

lol, JUST finished writing this

Code:



int flicka;



//somewhere in User_Initialization..

    flicka = 0;



//Where it says "put your autonomous code in here in user_routines_fast.c



   Pwm1_green = Pwm2_green = Pwm1_red = Pwm2_red = flicka = !flicka;

This flickers the green and red leds of Pwm1 and Pwm2 on the rc.
Hope this helps.