pic: Team 33 - Buzz 10
 

Re: pic: Team 33 - Buzz 10
 

Its very nice looking. How many can Buzz hold before they fall out?

Re: pic: Team 33 - Buzz 10
 

The most we've tried is four in the holder and one in the claw, and they seem to stay in pretty well.

Re: pic: Team 33 - Buzz 10
 

That's a pretty good number, and so far the best tetra holder i've seen.

Re: pic: Team 33 - Buzz 10
 

Wait until you see it drive....you might say it's not your average Killer Bees drivetrain ;)

Re: pic: Team 33 - Buzz 10
 

Woah, is that a roller of some kind I see on the side there?

Can't wait to see it in action, you guys always have great bots.

Re: pic: Team 33 - Buzz 10
 

Thanks, and yes it is a roller.

Re: pic: Team 33 - Buzz 10
 

What's the roller made out of?

Re: pic: Team 33 - Buzz 10
 

A solid aluminum rod with tapped holes at each end.

Re: pic: Team 33 - Buzz 10
 

I bet the roller is not part of the drive system but rather an anti-tipping device.

Re: pic: Team 33 - Buzz 10
 

You guessed right. We also have small wheels on the front and rear that serve the same purpose.

Re: pic: Team 33 - Buzz 10
 

Ah ok, that's what I was lookin for. As long as its not a part of the drive train, its ok. Looks great you guys. I love the hive look. Very cool.

Re: pic: Team 33 - Buzz 10
 

what about the arm? Does it extend, or just have those joints?

Re: pic: Team 33 - Buzz 10
 

No, it does not extend. However, it has a maximum height of over 10 feet from the floor.

Re: pic: Team 33 - Buzz 10
 

The roller is not what I was talking about when I mentioned the drive....guess again!


The arm only articulates at the two joints, and last I heard it's about a 10 foot reach.


...Eric beat me to the arm comment