Chief Delphi - BASIC stamps

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)

- Technical Discussion (http://www.chiefdelphi.com/forums/forumdisplay.php?f=22)

- - BASIC stamps (http://www.chiefdelphi.com/forums/showthread.php?t=37962)

Can anyone tell me which pins on the bottom of this BASIC stamp i connect a pwm wire into in order to connect it to the servo controller underneath it

Re: BASIC stamps

Phil,

To be safe you should check the parallax web site.....

Essentially all of the pins marked P# are available as inputs or outputs and so are eligible to be used for PWM outputs. I am not sure which servo controller you are using but typically they require a serial out line to the the controller. Again, any of the pins marked P# are available. You then use SEROUT to send the command to the servo controller. Check the documentation that came with your servo controller.

Check this thread for more info.