Chief Delphi

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)
-   Electrical (http://www.chiefdelphi.com/forums/forumdisplay.php?f=53)
-   -   What size breaker should I use for the RC? (http://www.chiefdelphi.com/forums/showthread.php?t=42057)

Excelsior 17-01-2006 17:10

What size breaker should I use for the RC?
 
Heh, silly question, but important, I'd think.

Sscamatt 17-01-2006 17:15

Re: What size breaker should I use for the RC?
 
<R89> You must protect the Robot Controller power feed with a 20A Circuit Breaker. You may not connect any
other electrical load to this breaker.

Be sure to read through the entire Manual before you wire. There are a lot of things that have to be done a specific way.

Excelsior 17-01-2006 17:15

Re: What size breaker should I use for the RC?
 
Thankee much.

SpaceOsc 17-01-2006 17:19

Re: What size breaker should I use for the RC?
 
Quote:

Originally Posted by Excelsior
Heh, silly question, but important, I'd think.




in the ROBOT section of the manual, 5.3.9.1 Circuit Breaker / Fusing Rules


there is a small picture next to rule <R90> and <R91> and shows you that it requires a 20amp fuse

-Osc




Al Skierkiewicz 18-01-2006 07:34

Re: What size breaker should I use for the RC?
 
Alex,
If you are using the supplied fuse blocks instead of the IFI block, I recommend that the first position (closest to the power stud) be used for the RC power. Any voltage drop in the fuse block is then minimized for the RC.


All times are GMT -5. The time now is 13:13.

Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Copyright © Chief Delphi