Chief Delphi - Sprockits and motors

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)

- Motors (http://www.chiefdelphi.com/forums/forumdisplay.php?f=52)

- - Sprockits and motors (http://www.chiefdelphi.com/forums/showthread.php?t=43307)

Ryo_Himura

04-02-2006 15:09

Sprockits and motors

Has anyone uses sprockets on their large CM motors

druman

04-02-2006 22:22

Re: Sprockits and motors

We mounted an extra transmission sprocket on the large CIM motor for the ball shooter, using a 5/16 transtorque and milling the sprocket bore to 3/4.

Henry_Mareck

04-02-2006 22:34

Re: Sprockits and motors

we plan to use a sprocket on one of our big CIMs too, though im not sure how it is attached.

lukevanoort

04-02-2006 23:39

Re: Sprockits and motors

We are and it's pretty easy, depending on how much force they have to be able to take. Just drop a properly sized sprocket on it and tighten the set screw.

JakeM

13-02-2006 22:04

Re: Sprockits and motors

We took the shiv off of the large CIM, then hardened it. We then machined an aluminum disk shaped part and the inner diameter was bored out until the hardened shiv could be cold pressed in. This creates a perfectly mating coupling piece that a sprocket could be mounted to. No problems yet, even after stalling the motor.

All times are GMT -5. The time now is 05:43.