Chief Delphi - Sensor Help

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)

- Programming (http://www.chiefdelphi.com/forums/forumdisplay.php?f=51)

- - Sensor Help (http://www.chiefdelphi.com/forums/showthread.php?t=43357)

Does anyone know how to set up a trans-beam receiver and trans-beam source?

Any help would be greatly appreciated.
Thanks :) :) :)

Quote:

Originally Posted by itzrobz

Does anyone know how to set up a trans-beam receiver and trans-beam source?

Any help would be greatly appreciated.
Thanks :) :) :)

Look on the side of each module......there is a little wiring digram. The transmitter (the one with 2 wires) gets 12v supplied. The receiver needs 5v. Each signal (NO and NC) gets pulled up with a resistor to 5v. You will need some perf board to get it all connected. You can choose to use either ouput, or both....each to its own digio.