error window during tracking...
 

- The CMUcam2 is connected through the serial port on the computer.
- Using a PWM wire to give power through the controller.
- In LabView for serial port, I selected COM1.
- Than I clicked the "Run" button.
- Everything is running fine.
- I click on Grab frame
- than I click on the color I want to track.
- Than the "Start Grabbing Binary Pixel Maps"...
- The camera begins to track!
- After about 5 seconds I get the following error...
"The application is closing becuase of a reported error. You should confirm that the correct serial port..." (the same message you get when the camera is actually not connected to the serial port.
- YET even after the message appears the camera continues to track!

This happens everytime!
please help!

Re: error window during tracking...
 

OK, I figured out what the problem was... The camera was not receiving enough voltage. (I used the power from the EDU-robot previously.)