Chief Delphi - pic: ball laucher

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)

- Extra Discussion (http://www.chiefdelphi.com/forums/forumdisplay.php?f=68)

- - pic: ball laucher (http://www.chiefdelphi.com/forums/showthread.php?t=43433)

Kyle A

06-02-2006 22:01

pic: ball laucher

loading photo ...

Goldeye

06-02-2006 22:01

Re: pic: ball laucher

Don't these small wheel demolish the ball?

Bemis

06-02-2006 22:36

Re: pic: ball laucher

They are six inches, I believe, same as our drive wheels, so not that small. We had no trouble with the wheels demolishing balls though. There isnt a whole lot of compression on them.

Arkorobotics

07-02-2006 17:35

Re: pic: ball laucher

Hey, what part did you use to connect those wheels to the shaft of the CIM motor?

Cody Carey

07-02-2006 17:57

Re: pic: ball laucher

http://www.chiefdelphi.com/forums/sh...619#post447619

There is a drawing here... and they are soft rubber, so there is NO problem tearing up the balls :)

Arkorobotics

07-02-2006 20:41

Re: pic: ball laucher

Quote:

Originally Posted by Cody C

http://www.chiefdelphi.com/forums/sh...619#post447619

There is a drawing here... and they are soft rubber, so there is NO problem tearing up the balls :)

go to McMaster and type in 2469k2, would that work? or would i rip up in place? :confused:

Cody Carey

07-02-2006 22:40

Re: pic: ball laucher

I would use the keyed one, or add a setscrew for each shaft, but yeah... That would probably work quite well :)

All times are GMT -5. The time now is 11:34.