Mounting the Gear Tooth Sensor???
 

My team needs some help mounting the gear tooth sensor on the kit transmission. We have the wires soldered and ready we just need to know how to mount it. If someone has a pic or something that would be great! Thanks.

Re: Mounting the Gear Tooth Sensor???
 

Copied from this thread: http://www.chiefdelphi.com/forums/sh...ad.php?t=43413

Re: Mounting the Gear Tooth Sensor???
 

We have looked at this and the picture isn't very clear about which gear it needs to be near, which washers are used, how the wires run out of the transmission, etc. Does anyone have a detailed picture or diagram?

Re: Mounting the Gear Tooth Sensor???
 

"Pre-drilled mounting holes for the Gear Tooth sensor module on the transmission covers, and using the GTS hardware supplied in the kit of parts will make installation particularly easy."

It doesn't go next to a sprocket. It goes next to the gear with the pre-drilled mounting holes beside it. The big thick plastic washers go under the board; the small thin plastic washers go above the board. You can see that if you look closely at the picture.

Run the wires out wherever it makes sense for the way you have it mounted to your chassis, taking care not to run them in the way of gears, sprockets, chains, etc.