Coasting
 

Hello

Currently our motors stop suddenly when we either change directions or want to bring the robot to a halt. Our team was wondering if there was a button which we could press on the OI or RC to make the robot coast :confused: . Thanks for your time and help.

Team 1852

Re: Coasting
 

almost

there is a little jumper on the Victor with two positions: C or B

coast or brake

Re: Coasting
 

There is a jumper on the actual Victor, but it should come by default in the coast setting (I think)... Try switching it to bridge the middle and the other outside pin.





Hope this helped :)

Re: Coasting
 

Our robot last year had a nifty little feature that the programers rigged up where the driver could switch between coasting and breaking just by fliping a switch on a joystick. The idea was that we could buy a little more time by coasting over the back line after the power went out and score a few more points. We ended up not really useing it a lot though, and kept it mainly on the brake setting.

But it was a nifty little feature nonetheless,

Re: Coasting
 

now that's nifty, we're going to hack a joystick that we're not using and make a buttin that will switch us from autonomous code to RC and vice versa. don't know if we;lll be able to do it or not but hopefully our mentor helps. It's possible, we just need the wiring to be correct.

Re: Coasting
 

In most cases, using the "brake" feature on drive controllers is a bad thing. The drivers feel they have no control over the robot and just when you least expect it, bam, the brake causes your robot to tip over.
Ligthwave, if you look on the IFI website, there is a pinout for the competition port and a diagram to make a switch that will disable the robot, enable for competition or enable auto mode. It is a very simple device to make, and is absolutely necessary in practice.