Invalid Address
 

I brought up the IFI Loader and tried to load up our hex file, but a message came up that said:

Invalid Address: 0x0 (correct Range: 0x800-0x7fff)

How do I fix this

Re: Invalid Address
 

What version of the IFI Loader are you using?

Sean

Re: Invalid Address
 

v-1-0-0

Re: Invalid Address
 

Uninstall 1.0.0 and install 1.1.0 (2 Feb 06)

http://www.ifirobotics.com/docs/ifi-loader-v1-1-0.zip

Post if it fixes your problem.

Sean

Re: Invalid Address
 

I still recieved an invalid address range error

Re: Invalid Address
 

Take a look at this thread:

http://www.chiefdelphi.com/forums/showthread.php?t=25662&highlight=Invalid+Address%3 A+0x0+%28correct+Range%3A+0x800-0x7fff%29

found this by searching for:
Invalid Address: 0x0 (correct Range: 0x800-0x7fff)

(search on the Orange bar above the ads)

(change the 18f8720.lkr with 18f8722.lkr - in the answer)

Sean

Re: Invalid Address
 

18f8722.lkr is the linker I have in it

Re: Invalid Address
 

Hmm, let's see. Maybe do a 'Clean' (Project, Clean in MPLab). Also, check to make sure the device in the Configure, Select Device is the 18F8722 processor.

Sean

Re: Invalid Address
 

Yes I have that device selected, now, when I am exporting the hex, do I need to edit anything on the window that pops up? Program Memory Areas?

Re: Invalid Address
 

under the program memory checked box it has Start:0 End:0x1fffe

Re: Invalid Address
 

I don't think you need to do the export. Just do a build (F10 or CTRL-F10) and then grab the .hex file that is created. I've never had to do export to get a .hex file that will load.

Sean

Re: Invalid Address
 

Well, when I clicked build all, it didn't do anything.

Re: Invalid Address
 

It sounds like a configuration problem. Has it worked in the past?

Sean

Re: Invalid Address
 

It built when I was over at Bosch, but it hasn't worked since I brought it here.

Re: Invalid Address
 

So, I have the program all ready to go, but I can't download it to the robot.