Chief Delphi - pic: Team 701 Mecanum Design View 2

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)

- Extra Discussion (http://www.chiefdelphi.com/forums/forumdisplay.php?f=68)

- - pic: Team 701 Mecanum Design View 2 (http://www.chiefdelphi.com/forums/showthread.php?t=50317)

Doug G

07-12-2006 13:28

pic: Team 701 Mecanum Design View 2

loading photo ...

Tom Bottiglieri

07-12-2006 13:28

Re: pic: Team 701 Mecanum Design View 2

So, you're drilling a hole through a bolt?

Ben Piecuch

07-12-2006 13:44

Re: pic: Team 701 Mecanum Design View 2

2, actually.

Come on Tom, you can't tell me that the Cyberknights haven't done that! :) (I'm sure GUS has done it.)

BEN

Salik Syed

13-12-2006 19:27

Re: pic: Team 701 Mecanum Design View 2

Assuming everything fits snugly how are you going to tilt the gearbox forward, the two vertical bolts will move forward when you tilt the tranny down and not line up with the bottom bolt (??) I guess you will oversize the holes in the threaded rod???

Alekat

06-03-2007 02:02

Re: pic: Team 701 Mecanum Design View 2

Quote:

Originally Posted by Tom Bottiglieri (Post 539764)

So, you're drilling a hole through a bolt?

Actually no, you would certainly want to use a piece of shaft and just thread that. It's tedious, I know, but it gives the strength you want with something holding your gearbox.

Salik, I'm thinking both of the shafts would be allowed to rotate, the gearbox should tension nicely if everything is lined up to begin with.

All times are GMT -5. The time now is 00:38.