Configuring Labview code to easyC
 

Hi there, after lots of troubleshooting I got to where i should save labview to easyC code and when i did that it did not save it as a .ECC file it saved it as a configuration setting. Therefore when i tried to run it on easyC it wasnt there. If you can help me settle this problem it would be greatly appreciated.





Thank you....
Adam, Programming

Re: Configuring Labview code to easyC
 

Once you load the labview file into easyC it will save those values in the current project.

Re: Configuring Labview code to easyC
 

But doesnt it have to be saved as a easyC format to do this in the first place???

Re: Configuring Labview code to easyC
 

Oh, I get it, can you e-mail me that file to amartin "at" intelitek.com

Re: Configuring Labview code to easyC
 

I sent out the email to your email

Re: Configuring Labview code to easyC
 

When you guys get your issue resolved, do you mind posting your results?

-Danny

Re: Configuring Labview code to easyC
 

Labview changed the file to a .ini from a .ecc. So just rename the file labview generates to a .ecc and easyC will load it. We will update easyC in the next build.