pic: Team 8 Graber
 

Re: pic: Team 8 Graber
 

Looks like an interesting concept.

Do you have any provisions for protecting the Globe motor in the pipeline?

Re: pic: Team 8 Graber
 

How do you intend to pick up a deflated tube?

Re: pic: Team 8 Graber
 

Does it close of Just spinnings the Donut thing in?

Re: pic: Team 8 Graber
 

http://www.chiefdelphi.com/forums/sh...ad.php?t=51657

Which one came first?

Re: pic: Team 8 Graber
 

Intresting I have a question for you are they just trying to only puy them on or are they trying to also remove the Spoilers and move them?

Re: pic: Team 8 Graber
 

This is a reply to the posts so far.

No current thoughts about how to protect the motors.

The design allows for the jaw to change sizes but this was just to figure out how the motors would function.
the one at this address came first.
http://www.chiefdelphi.com/forums/sh...ad.php?t=51657

Design concept allows for a possibility of taking off ringers but not exactly sure if we will be doing that or just placing ringers.

Re: pic: Team 8 Graber
 

Are you going to motorize the two outermost rollers seperately so you can rotate the tube while you're holding it?

Re: pic: Team 8 Graber
 

OK

Re: pic: Team 8 Graber
 

Richard: yup, thos two will be motorized individually.

Hopefuly we'll be able to also remove spoilers.

Gabe: We're not sure. We might make some of it it adjustble if it seems that many tubes are deflated during regionals.

-Guy

Re: pic: Team 8 Graber
 

Yeah becaue i was wondering how you guys could get spoilers off like the dsign is good on putting the keepers on but removing spoilers.... but I think it could work.

Re: pic: Team 8 Graber
 

Hey. . .That's pipe insulation! Way to be creative!:D

Re: pic: Team 8 Graber
 

How well does the foam material grip the inner tube?