Chief Delphi - Frustrated by McMaster-Carr

Page 4 of 4

Show 100 post(s) from this thread on one page

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)

- General Forum (http://www.chiefdelphi.com/forums/forumdisplay.php?f=16)

- - Frustrated by McMaster-Carr (http://www.chiefdelphi.com/forums/showthread.php?t=52597)

mathking

26-01-2007 12:35

Re: Frustrated by McMaster-Carr

We had the same issue with the sprockets (though we did see it before we ordered and determined that our application could be done by pinning and then welding the sprocket).

As for McMaster's service, we have placed 11 orders for $1477 and everything has been next day except for one item the web site let us know was not in stock. We did set up an open PO with them at the start of the season so all of the placing of orders is a call and a fax and its done. Our treasurer at school wishes all vendors were as easy for her to deal with.

Cory	26-01-2007 16:46

Re: Frustrated by McMaster-Carr

Quote:

Originally Posted by billbo911 (Post 565669)

I went back to the McMaster-Carr site to verify. As much as I hate to admit it, I was wrong. Exactly as you said, it IS there in black and white. I missed it. "except 1/4", 3/8", and 1/2" bore sizes, which do not have keyways. "

I stand corrected.
Now, any ideas where, in the Sacramento area, I might be able to get these broached????

Check the yellow pages in your local phone book and give any of the machine shops in there a call. You should be able to find one willing to broach your sprockets for a small fee, if not for free.

All times are GMT -5. The time now is 14:46.

Page 4 of 4

Show 100 post(s) from this thread on one page