rule <g29> and flag
 

does our flag count toward dimensions on our robot? we were thinking about making a robot 36" but the flag would go over the 38" rule, allowing for us to stay upright instead of sitting on end, as stated by gdc in the q&a forums here. does this violate rules or isnt ethical or doesnt count? or is it legal?

Re: rule <g29> and flag
 

well, first of all, i would guess that you meant that the rule was 48 inches.. because it is, and no, the flag does not count as the overall hieght.

Re: rule <g29> and flag
 

no i meant as in that since the longest dimension has to be the vertical one at the beginning then that means that a 28*38 robot that is 36" high must start on the 38" side. with this i mean that first of all which side do they want the flag on since a flag holder modified to change the orientation of the flag would likely be illegal so if we end up changing the "vertical" side of our robot then which side would it have to be on? and second does the flag (something that would put said 36" robot over 38", therefore making the other side the max dimension and totally putting the rule out of wack) change the sizing?

Re: rule <g29> and flag
 

From <R11>:

and from <R15>

Any other questions?

Mike

Re: rule <g29> and flag
 

They even state in the Q&A that if flopping is an issue then make a mast higher than your length an then you wouldn't have to flop over.