Chief Delphi

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)
-   Motors (http://www.chiefdelphi.com/forums/forumdisplay.php?f=52)
-   -   gear tooth sensors purchasing (http://www.chiefdelphi.com/forums/showthread.php?t=53221)

wedellm 01-02-2007 15:57

gear tooth sensors purchasing
 
Has anyone found where we can purchase the sensor as well as the board? I have found the sensor, but not the circuit board. If anyone is not using their gear tooth sensors and circuit boards, we would like to buy theirs.

Jared Russell 02-02-2007 11:20

Re: gear tooth sensors purchasing
 
That would most likely not be legal. Custom FIRST parts are not COTS, so you are generally limited to what they gave you for a given robot.

I will look for boards, though.

Jared Russell 02-02-2007 11:48

Re: gear tooth sensors purchasing
 
I can't find any boards from Allegro. However, I did find some other possible substitutes:

http://www.bbautomacao.com/pdfs/Gear...h%20Sensor.pdf

These act in exactly the same way, but don't have the same "zero speed" capabilities, i.e. their outputs might drift below 10 rpm a bit. The plastic one costs $18.

wedellm 02-02-2007 16:28

Re: gear tooth sensors purchasing
 
I do not think it would illegal since they sold them through IFI last year.

Jared Russell 02-02-2007 19:35

Re: gear tooth sensors purchasing
 
From the FIRST manual:

<R28> COTS ITEMS that are generally available may be used on the ROBOT. COTS ITEMS from
ROBOTS entered in previous FIRST competitions or COTS ITEMS that are no longer
commercially available may be used under the following conditions:
° The item must be unmodified, and still in its original condition as delivered from the
VENDOR
° The item must not be a part custom made for the FIRST competition and provided in a
previous FRC Kit Of Parts (e.g. 2006 FRC transmissions, custom-made motor couplers,
custom sensor strips, IFI CMUcam II modules, etc. are not permitted)
° The item must satisfy ALL of the rules associated with materials/parts use for the 2007
FIRST Robotics Competition

Also note that last year's gear-tooth sensors were a different model, and they are no longer available, and therefore not COTS because not all teams can get them.

roboticsguy1988 07-02-2007 20:50

Re: gear tooth sensors purchasing
 
So nobody knows where to get the sensor and the board already together? We are looking for the 2005 gear tooth sensor (with the board). Considering it would be off the shelf they should be legal.


All times are GMT -5. The time now is 08:52.

Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Copyright © Chief Delphi