Logos
 

What are we supposed to use to put our logos onto the robot?

Re: Logos
 

Hand-painting. Stickers. Custom vinyl decals. Engraving or milling. Wood-burning. Laser etching. Et cetera.

We will probably print out our side-panel graphics and affix the paper to the inside of a thin sheet of lexan. Or perhaps we'll have it printed on plastic this year. I don't know the plan, but I'm assured it's under control.

Re: Logos
 

We have ours printed on paper and are considering elaminating it. We tried tape last year but got turned away and had to replace it with a certain glue. I am just trying to find an easy solution without getting turned away again.

Re: Logos
 

This year, I finally got smart about using the resources around me, particularly the large-format printer in the College of Arts and Sciences computer lab. $16.25 bought a right large amount of graphics for the robot, which we laminated at the school today and will velcro to the robot. Overall, it looks great, even where I forgot like an idiot to provide means to reach the main breaker. (The trick was that I didn't put anything fancy on the sides, so I could cut as needed without guilt.)