Chief Delphi - pic: 781 robot lift

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)

- Robot Showcase (http://www.chiefdelphi.com/forums/forumdisplay.php?f=58)

- - pic: 781 robot lift (http://www.chiefdelphi.com/forums/showthread.php?t=54680)

d.courtney

20-02-2007 17:16

pic: 781 robot lift

loading photo ...

trilogism

20-02-2007 17:16

Re: pic: 781 robot lift

What happens if you have a robot on only one side? Would you tip over?

Dantvman27

20-02-2007 17:18

Re: pic: 781 robot lift

Quote:

Originally Posted by trilogism (Post 582654)

What happens if you have a robot on only one side? Would you tip over?

ya looks that way

d.courtney

20-02-2007 21:07

Re: pic: 781 robot lift

at the moment yes, but that will likely change after the first regional

Vince lau

21-02-2007 10:41

Re: pic: 781 robot lift

the ramp on the right, the one with Bruce C looks like its on an angle, if a robot had its wheels on the ramp would it roll off?

d.courtney

21-02-2007 11:38

Re: pic: 781 robot lift

Quote:

Originally Posted by Vince lau (Post 583264)

the ramp on the right, the one with Bruce C looks like its on an angle, if a robot had its wheels on the ramp would it roll off?

nope... have made a design change to stop that, and allow the ability to lift just one robot

waiakea2024

21-02-2007 12:37

Re: pic: 781 robot lift

Does your robot move? Also how does another robot climb?

waiakea11

21-02-2007 12:40

Re: pic: 781 robot lift

wow...

d.courtney

21-02-2007 14:59

Re: pic: 781 robot lift

Quote:

Originally Posted by waiakea2024 (Post 583317)

Does your robot move? Also how does another robot climb?

we lift both ourselves and either two robots or one (once we install our outrigger) using the large cim and a 144:1 gear reduction (this same motor is used for our arm with 12:1 gear reduction, we use a clutch to choose between the lift and the arm up/down). before lifting, there is a 1 inch platform for a robot to place themselves over... hope this answered your question

All times are GMT -5. The time now is 10:20.