pic: Dimensions of the Trackball on the Overpass
 

Re: pic: Dimensions of the Trackball on the Overpass
 

did you make the 32" wide overpass on center of the pipes or on the edges?

cause my number don't line up exactly with yours.

here are mine:
http://www.chiefdelphi.com/forums/at...6&d=1199655203

Re: pic: Dimensions of the Trackball on the Overpass
 

I used
32" from center of the pipe to center of the pipe all the way around to form a square.
.75in radius for the pipe from the 1-1/2 steel pipe.
the 40" Trackball.
I made half of the ball in the center of the square and made the arc tagent to the pipe and vertical with the center of the mid point and revolved the ball, then I created a sketch through the center, and projected the geometries of the ball and the bottum of the pipe, returned, and there you go.