Chief Delphi - taigene motor shaft

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)

- Technical Discussion (http://www.chiefdelphi.com/forums/forumdisplay.php?f=22)

- - taigene motor shaft (http://www.chiefdelphi.com/forums/showthread.php?t=62310)

wildabyss

22-01-2008 21:02

taigene motor shaft

Taigene motor has a rectangular end on its shaft. What coupler should I use to, for example, connect it to a 1/2'' shaft?

Jaybee1405

22-01-2008 21:59

Re: taigene motor shaft

possibly mount a gear on the output shaft of the Taigene and on the 1/2 inch shaft and mesh the gears together

that way you'll also be able to control the reduction

LH Machinist

23-01-2008 11:56

Re: taigene motor shaft

The main shaft is 11mm round and the easist method of attachment is; drill your pulley to 11mm (slightly smaller than 7/16) and then use a 3/32 roll pin to secure it to the motor shaft.

wildabyss

24-01-2008 17:11

Re: taigene motor shaft

A large portion of the shaft has a rounded rectangular shape. Is there any easy way to use that?

All times are GMT -5. The time now is 14:21.