pic: 1225's 2008 Electrical Board
 

Re: pic: 1225's 2008 Electrical Board
 

really cool man !!! we are workin on ours ...... still... we had our robot rollin by saturday but instead of the plexiglass we had wood ... so right now we disassemble everything to use plexiglass....

Re: pic: 1225's 2008 Electrical Board
 

i wish we had that much room..

Re: pic: 1225's 2008 Electrical Board
 

x2....looks good tho

Re: pic: 1225's 2008 Electrical Board
 

Are you going to use an external Prog./Reset Switch? Is it going to be removable? It is looking good, you have plenty of room for running wires. Good Luck!

Re: pic: 1225's 2008 Electrical Board
 

Its really pretty!!

I wish I had the patient for the cleaning up the wires:)

It looks so good!

If you are living somewhere near minnesota come and clean my wires, too!!

LoL!! Haha!!

Re: pic: 1225's 2008 Electrical Board
 

Looks pretty good. Last year, IFI had recommended that the radio modem be mounted vertically (there's an antenna inside the case, in addition to the external one). For safety, I'd put a little electrical tape on the positive connection to the ATC panel, since it's very close to the negative.

Do you have enough room on the right side to get the serial cables in and out of the robot controller once it's mounted on the robot? They take up quite a bit of room.

Re: pic: 1225's 2008 Electrical Board
 

Thats what I was going to say. IFI also recommended that it be mounted 3 feet or so in the air. We mounted ours on our mast and never had a radio problem last year.