Chief Delphi - Question about the Pressure Switch

Chief Delphi (http://www.chiefdelphi.com/forums/index.php)

- Pneumatics (http://www.chiefdelphi.com/forums/forumdisplay.php?f=54)

- - Question about the Pressure Switch (http://www.chiefdelphi.com/forums/showthread.php?t=62407)

Bomberofdoom

24-01-2008 09:20

Question about the Pressure Switch

hey,

Our Pressure switch stops at 110psi.

Any idea why?

Thanks,

Al Skierkiewicz

24-01-2008 09:23

Re: Question about the Pressure Switch

The pressure switch is not terribly accurate. That being said, it should allow your system to reach in the 120-130 PSI range. It might be defective and would then need to be replaced.

MrForbes

24-01-2008 09:28

Re: Question about the Pressure Switch

The pneumatics manual says it is supposed to trip at 115 psi.....

TubaMorg

24-01-2008 11:00

Re: Question about the Pressure Switch

ours has always tripped at 110 - 115 psi indicated pressure. We run the compressor 5-7 seconds longer to reach 120 (programming).

All times are GMT -5. The time now is 17:07.